English

Home › Family › Lithium Batteries for Electric Stackers

Forklift family — application page

Lithium Batteries for Electric Stackers

Electric stackers are named in the 48V 450Ah power system's own application statement, in the same list as electric forklifts, electric tractors and electric flatbed vehicles. The forklift family therefore covers stacker duty with two anchor systems, selected by load and integration rather than by vehicle badge.

Illustration of a forklift lifting a battery unit

The stacker application

The 450Ah system's application line is explicit: it is the dedicated power system for electric forklifts, electric tractors, electric stackers and electric flatbed vehicles. A stacker enquiry therefore starts from a specified system, not from a forklift page stretched to fit: 250A continuous and 600A peak discharge, 12kW maximum load, charge at 50A standard and 120A maximum, CAN plus RS-485 communication, a 350A Anderson connector and 3000+ cycles, in a 708×673×970mm, roughly 280kg sheet-metal system.

Choosing between the two systems for a stacker

Heavy stacker and tractor duty — high lift loads, long travel, two shifts — spends the 450Ah system's current and energy headroom. A lighter stacker integrated into a PLC-controlled handling line is the 250Ah system's territory: 100A maximum discharge, 4kW maximum load, CAN protocol provided for PLC reading with SOC accuracy of ≤5%, IP53 and ≥2000 cycles at stated conditions, at about 115kg. The deciding facts are the truck's load requirement, the shift's measured energy, and whether the machine's controller will read the battery over CAN; state all three in the enquiry and the system choice is made on the figures.

Specifying a stacker enquiry

Send the stacker model and its compartment dimensions, the lift and travel duty (loads, heights, shift length), the measured or estimated shift energy, and the break structure if opportunity charging is planned against the systems' charge pairs (50A standard with 120A or 100A maximum). The reply names the system, the charger sizing that follows from its charge pair, and the installation checks — extraction path, connector, communication interface — the installation will need.

Stacker duty against the two systems

A stacker sits between the family's two systems in duty, and the selection reads off their tables directly. Energy per shift decides first: a stacker working one shift on pedestrian duty commonly lives inside the 250Ah system's 12kWh, while a two-shift rider machine reaches for the 450Ah system's 21.6kWh. Integration decides second: the 250Ah system's CAN-for-PLC provision and ≤5% SOC accuracy suit machines whose controllers manage their own energy, while the 450Ah system's CAN plus RS-485 pair suits fleet-managed sites. Handling decides third: 115kg against 280kg is the difference between a workshop lift and a crane plan. Bring the shift pattern and the machine's controller context to the enquiry; the stacker answer is one of the two systems, quoted against its own table.

Request a quote

Send the model or your target specification — voltage, capacity, discharge current and envelope.

Related pages