English

Home › Energy Storage Batteries

Energy storage family

Energy Storage Batteries

The storage family is built on 51.2V LiFePO4 systems with cycle-life and communication data. The wall-mounted 51.2V 100Ah unit is the anchor — ≥6000 cycles at 90% depth of discharge, RS485, CAN and RS232 ports, and up to 16 units in parallel — and a 51.2V 200Ah model and rack / stacked formats extend the same platform to 600Ah.

Illustration of a wall-mounted battery unit with a display screen

Key data — Energy Storage Batteries

Platform51.2V LiFePO4, 3.2V cells
Anchor unit51.2V 100Ah wall-mounted, ≥6000 cycles
CommunicationRS485, CAN, RS232 (anchor unit)
ParallelUp to 16 units (anchor unit)

Formats

The legacy catalogue also runs to a 48V 100Ah wall-mounted storage title; the current wall unit's nominal is 51.2V (16S) — see the model page. "48V" is a system-compatibility class, not this unit's nominal voltage.

Selecting a storage format

The three formats divide by installation, not by performance — all share the 51.2V platform and the anchor model's data. Wall format suits houses and small commercial walls where the shallow 150mm profile is the point. Rack format suits cabinets, plant rooms and installations that will be serviced by technicians. Stacked format suits floor space and staged growth. Capacity planning starts from the anchor: 5.12kWh per unit, about 4.6kWh usable at the rated depth, sixteen units maximum in parallel — a range that covers a flat's evening shift at the bottom and a small factory's critical loads at the top.

Choosing between wall, rack and stacked formats

The three formats store the same cells' energy in different ownership shapes. The wall unit is a finished appliance: one SKU, one wall, an afternoon's installation, capacity growing in 5.12kWh steps to the 40.96kWh ceiling. The rack format is a cabinet discipline: it belongs where other 19-inch equipment already lives, where service access is frontal and where the operator thinks in shelves rather than rooms. The stacked format is the floor-standing middle: modules pile without wall fixings, capacity steps are physical, and the format suits rented buildings and plant rooms where walls are not the installer's to drill. The electrical specification does not choose between them — the building does — and the enquiry that names its building (wall structure, cabinet presence, floor space) gets the format recommendation as a conclusion rather than a guess.

Related pages